Connectivity Guide
Command Mode VLAN INTERFACE
Usage Information
This command is applicable only for VLAN interfaces.
In a non-VLT network, the backup VRRP gateway forwards L3 trac. If you want to use VRRP groups on VLANs
without VLT topology, disable the Active-Active functionality, to ensure that only the active VRRP gateway
forwards L3 trac.
The no version of this command disables the conguration.
Example
OS10(conf-if-vl-10)# vrrp mode active-active
Supported Releases 10.2.0E or later
1070 Virtual Link Trunking