Connectivity Guide

iscsi priority-bits
Resets the priority bitmap advertised in iSCSI application TLVs.
Syntax iscsi priority-bits {priority-bitmap}
Parameter priority-bitmap — Enter a bitmap value for the dot1p priority advertised for iSCSI trac in iSCSI application
TLVs (0x1 to 0x).
Default 0x10 (dot1p 4)
Command Mode CONFIGURATION
Usage Information iSCSI trac uses dot1p priority 4 in frame headers by default. Use this command to recongure the dot1p-priority
bits advertised in iSCSI application TLVs. Enter only one dot1p-bitmap value — setting more than one bitmap value
with this command is not supported. The default dot1p 4 value advertises only if you enabled PFC pause frames for
dot1p 4 trac using the pfc-cos dot1p-priority command. The no version of this command resets to the
default value.
Example
OS10(config)# iscsi priority-bits 0x20
Supported Releases 10.3.0E or later
iscsi prole-storage
Congures a port for direct connection to a storage device that is not automatically detected by iSCSI.
Syntax
iscsi profile-storage storage-device-name
Parameter storage-device-name — Enter a user-dened name of a storage array that iSCSI does not automatically
detect.
Default Not congured
Command Mode INTERFACE
Usage Information Congure directly attached storage arrays that iSCSI supports if they are not automatically detected. This
command is required for storage devices that do not support LLDP. The no version of this command disables the
connection.
Example
OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant
Supported Releases 10.3.0E or later
iscsi session-monitoring enable
Enables iSCSI session monitoring.
Syntax
iscsi session-monitoring enable
Parameter None
Default Disabled
Command Mode CONFIGURATION
Converged data center services 1109