Connectivity Guide

location-led interface
Changes the location LED of the interface.
Syntax
location-led interface ethernet {chassis/slot/port[:subport]} {on | off}
Parameters
• chassis/slot/port[:subport] — Enter the ethernet interface number.
• on | off — Set the interface LED to be on or o.
Default Not congured
Command Mode EXEC
Usage Information Use this command to change the location LED for the specied interface.
Example
OS10# location-led interface ethernet 1/1/1 on
OS10# location-led interface ethernet 1/1/1 off
Supported Releases 10.3.0E or later
location-led system
Changes the location LED of the system.
Syntax
location-led system {node-id | node-id/unit-id} {on | off}
Parameters
• node-id | node-id/unit-id — Enter the system ID.
• on | off — Set the system LED to be on or o.
Default Not congured
Command Mode EXEC
Usage Information Use this command to change the location LED for the specied system ID.
Example
OS10# location-led system 1 on
OS10# location-led system 1 off
Supported Releases 10.3.0E or later
ping
Tests network connectivity to an IPv4 device.
Syntax
ping [vrf {management | vrf-name}] [-4] [-aAbBdDfhLnOqrRUvV] [-c count] [-i
interval] [-I interface] [-m mark] [-M pmtudisc_option] [-l preload] [-p
pattern] [-Q tos] [-s packetsize] [-S sndbuf] [-t ttl] [-T timestamp_option] [-
w deadline] [-W timeout] [hop1 ...] destination
Parameters
• vrf management — (Optional) Pings an IPv4 address in the management virtual routing and forwarding
(VRF) instance.
• vrf vrf-name — (Optional) Ping an IP address in a specied VRF instance.
Troubleshoot OS10 1159