Connectivity Guide

• log-debug — Set to debug messages.
Default Log-notice
Command Mode CONFIGURATION
Usage Information
To reset the monitor severity to the default level, use the no logging monitor severity command. The
default severity level is log-notice.
Example
OS10(config)# logging monitor severity log-info
Supported Releases 10.2.0E or later
logging server
Congures the remote syslog server.
Syntax
logging server {hostname | ipv4–address | ipv6–address} [severity severity-
level | vrf management [severity severity-level] [tcp port-number | udp port-
number]
Parameters
• hostname | ipv4–address | ipv6–address — (Optional) Enter either the hostname or IPv4/IPv6
address of the logging server.
• vrf management — (Optional) Congure the logging server for the management VRF instance.
• severity-level — (Optional) Set the logging threshold severity:
– log-emerg — System as unusable.
– log-alert — Immediate action is needed.
– log-crit — Critical conditions.
– log-err — Error conditions.
– log-warning — Warning conditions.
– log-notice — Normal but signicant conditions, the default.
– log-info — Informational messages.
– log-debug — Debug messages.
• tcp port-number — (Optional) Send syslog messages over TCP to a specied port on a remote logging
server, from 1 to 65535.
• udp port-number — (Optional) Send syslog messages over UDP to a specied port on a remote logging
server, from 1 to 65535; default 514.
Defaults
System messages of the log-notice security level and lower are generated.
Syslog messages are sent over UDP to port 514 on a remote logging server.
Command Mode CONFIGURATION
Usage Information Starting from 10.3.0E or later, this command supports IPv6 addresses. The previous versions support only IPv4
addresses. The no version of this command deletes the syslog server.
Example
OS10(config)# logging server dell.com severity log-info
OS10(config)# logging server fda8:6c3:ce53:a890::2 tcp 1468
OS10(config)# logging server dell.com vrf management severity log-debug
Troubleshoot OS10 1195