Connectivity Guide

Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command disables broadcast.
Example
OS10(conf-if-eth1/1/1)# ntp broadcast client
Supported Releases 10.2.0E or later
ntp disable
By default, NTP is enabled on all interfaces. Prevents an interface from receiving NTP packets.
Syntax
ntp disable
Parameters None
Default Enabled
Command Mode INTERFACE
Usage Information USe this command to congure OS10 to not listen to a particular server and prevent the interface from receiving
NTP packets. The no version of this command re-enables NTP on an interface.
Example
OS10(conf-if-eth1/1/7)# ntp disable
Supported Releases 10.2.0E or later
ntp enable vrf
Enables NTP for the management or non-default VRF instance.
Syntax
ntp enable vrf {management | vrf vrf-name}
Parameters
• management — Enter the keyword to enable NTP for the management VRF instance.
• vrf vrf-name — Enter the keyword then the name of the VRF to enable NTP for that non-default VRF
instance.
Defaults Disabled
Command Mode CONFIGURATION
Usage Information The no version of this command disables NTP for the management VRF instance.
Example
OS10(config)# ntp enable vrf management
OS10(config)# ntp enable vrf vrf-blue
Supported Releases 10.4.0E(R1) or later
ntp master
Congures an NTP master server.
Syntax
ntp master stratum
Parameters stratum — Enter the stratum number to identify the NTP server hierarchy, from 2 to 10.
126 System management