Connectivity Guide

Example
OS10(conf-dhcp-static)# hardware-address 00:01:e8:8c:4d:0a
Supported Releases 10.2.0E or later
host
Assigns a host to a single IPv4 or IPv6 address pool for manual congurations.
Syntax
host A.B.C.D/A::B
Parameters A.B.C.D/A::B — Enter the host IP address in A.B.C.D or A::B format.
Default Not congured
Command Mode DHCP-POOL
Usage Information The host address is the IP address used by the client machine for DHCP.
Example
OS10(conf-dhcp-Dell)# host 20.1.1.100
Supported Releases 10.2.0E or later
ip dhcp server
Enters DHCP mode.
Syntax
ip dhcp server
Parameters None
Default Not congured
Command Mode CONFIGURATION
Usage Information This command is used to enter DHCP mode.
Example
OS10(config)# ip dhcp server
OS10(conf-dhcp)#
Supported Releases 10.2.0E or later
ip helper-address
Congure the DHCP server address. Forwards UDP broadcasts received on an interface to the DHCP server. You can congure multiple
helper addresses per interface by repeating the same command for each DHCP server address.
Syntax
ip helper-address address [vrf vrf-name]
Parameters
• address — Enter the IPv4 address to forward UDP broadcasts to the DHCP server in A.B.C.D format.
• vrf vrf-name — (Optional) Enter vrf and then the name of the VRF through which the host address is
reached.
Default Disabled
Command Mode INTERFACE
140 System management