Connectivity Guide

Figure 4. S4148U-ON unied port groups
To enable Ethernet interfaces in a unied port group:
1 Congure a unied port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the switch.
port-group node/slot/port-group
2 Activate the unied port group for Ethernet operation in PORT-GROUP mode. To activate a unied port group in Fibre Channel mode,
see Fibre Channel interfaces. The available options depend on the switch.
mode Eth {100g-1x | 50g-2x | 40g-1x | 25g-4x | 10g-4x}
• 100g-1x — Reset a port group to 100GE mode.
• 50g-2x — Split a port group into two 50GE interfaces.
• 40g-1x — Set a port group to 40GE mode for use with a QSFP+ 40GE transceiver.
• 25g-4x — Split a port group into four 25GE interfaces.
• 10g-4x — Split a port group into four 10GE interfaces.
3 Return to CONFIGURATION mode.
exit
4 Enter Ethernet Interface mode to congure other settings. Enter a single interface, a hyphen-separated range, or multiple interfaces
separated by commas.
interface ethernet node/slot/port[:subport]
Congure Ethernet unied port interface
OS10(config)# port-group 1/1/13
OS10(conf-pg-1/1/13)# mode Eth 25g-4x
OS10(conf-pg-1/1/13)# exit
OS10(config)# interface ethernet 1/1/41:1
OS10(conf-if-eth1/1/41:1)#
View Ethernet unied port interface
OS10(config)# interface ethernet 1/1/41
OS10(conf-if-eth1/1/41:1)# show configuration
!
interface ethernet1/1/41:1
no shutdown
Z9264F-ON port-group proles
On the Z9264F-ON switch, the port-group proles determine the available front-panel Ethernet ports and supported breakout interfaces.
QSFP28 ports operate only in Ethernet mode. Use the port-group prole to congure breakout interfaces and specify the port speed.
NOTE
: The conguration steps to enable Ethernet interfaces on a Z9264F-ON port group are dierent than that of the S4100-
ON series. Follow the procedure described in this section to congure breakout interfaces on a Z9264F-ON switch.
Interfaces 149