Connectivity Guide

View interface conguration
To view basic interface information, use the show interface, show running-configuration, and show interface status
commands. Stop scrolling output from a show command by entering CTRL+C. Display information about a physical or virtual interface in
EXEC mode, including up/down status, MAC and IP addresses, and input/output trac counters.
show interface [type]
phy-eth node/slot/port[:subport] — Display information about physical media connected to the interface.
status — Display interface status.
ethernet node/slot/port[:subport] — Display Ethernet interface information.
loopback id — Display Loopback interface information, from 0 to 16383.
mgmt node/slot/port — Display Management interface information.
port-channel id-number — Display port-channel interface information, from 1 to 128.
vlan vlan-id — Display the VLAN interface information, from 1 to 4093.
View interface information
OS10# show interface
Ethernet 1/1/1 is up, line protocol is down
Hardware is Eth, address is 00:0c:29:66:6b:90
Current address is 00:0c:29:66:6b:90
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR4
Wavelength is 64
Receive power reading is 0.000000 dBm
Interface index is 15
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Enabled
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 0, Auto-Negotiation on
Configured FEC is off, Negotiated FEC is off
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 02:46:35
Queuing strategy: fifo
Input statistics:
0 packets, 0 octets
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output statistics:
0 packets, 0 octets
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 Collisions, 0 wred drops
Rate Info(interval 30 seconds):
Input 0 Mbits/sec, 0 packets/sec, 0% of line rate
Output 0 Mbits/sec, 0 packets/sec, 0% of line rate
Time since last interface status change: 02:46:36
Ethernet 1/1/2 is up, line protocol is up
Hardware is Eth, address is 00:0c:29:66:6b:94
Current address is 00:0c:29:66:6b:94
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR4
Wavelength is 64
Receive power reading is 0.000000 dBm
Interface index is 17
170
Interfaces