Connectivity Guide

Interface commands
channel-group
Assigns an interface to a port-channel group.
Syntax
channel-group channel-number mode {active | on | passive}
Parameters
• channel-number — Enter a port-channel number, from 1 to 128.
• mode — Sets LACP Actor mode.
• active — Sets Channeling mode to Active.
• on — Sets Channeling mode to static.
• passive — Sets Channeling mode to passive.
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default, and unassigns the interface from the port-channel
group.
Example
OS10(config)# interface ethernet 1/1/2:1
OS10(conf-if-eth1/1/2:1)# channel-group 20 mode active
Supported Releases 10.3.0E or later
default vlan-id
Recongures the VLAN ID of the default VLAN.
Syntax
default vlan-id vlan-id
Parameters vlan-id — Enter the default VLAN ID number, from 1 to 4093.
Default VLAN1
Command Mode CONFIGURATION
Usage Information By default, VLAN1 serves as the default VLAN for switching untagged L2 trac on OS10 ports in Trunk or Access
mode. If you use VLAN1 for network-specic data trac, recongure the VLAN ID of the default VLAN. The
command recongures the access VLAN ID, the default VLAN, of all ports in Switchport Acess mode. Ensure that
the VLAN ID exists before conguring it as the default VLAN.
Example
OS10(config)# default vlan-id 10
OS10(config)# do show running-configuration
...
!
interface vlan1
no shutdown
!
interface vlan10
no shutdown
!
interface ethernet1/1/1
Interfaces 175