Connectivity Guide

Usage Information You can only use this command on the Management port. The no version of this command removes the duplex
mode conguration from the management port.
Example
OS10(conf-if-ma-1/1/1)# duplex auto
Supported Releases 10.3.0E or later
enable dom
Enables or disables the DOM feature.
Syntax
dom enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage Information The no version of this command disables digital optical monitoring.
Example
OS10# configure terminal
OS10(config)# dom enable
OS10# configure terminal
OS10(config)# no dom enable
Supported Releases 10.4.3.0 or later
enable dom traps
Enables DOM traps if the specied parameter crosses the dened threshold three times.
Syntax
snmp-server enable traps dom {temperature | voltage | rx-power | tx-power |
bias}
Parameters temperature | voltage | rx-power | tx-power | bias — Enter the keyword to enable DOM
traps for the specied category.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command disables the DOM traps.
Example
OS10# configure terminal
OS10(config)# snmp-server enable traps dom temperature
OS10# configure terminal
OS10(config)# no snmp-server enable traps dom temperature
Supported Releases 10.4.3.0 or later
Interfaces 177