Connectivity Guide

interface vlan
Creates a VLAN interface.
Syntax
interface vlan vlan-id
Parameters vlan-id — Enter the VLAN ID number, from 1 to 4093.
Default VLAN 1
Command Mode CONFIGURATION
Usage Information FTP, TFTP, MAC ACLs, and SNMP operations are not supported. IP ACLs are supported on VLANs only. The no
version of this command deletes the interface.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)#
Supported Releases 10.2.0E or later
link-bundle-utilization
Congures link-bundle utilization.
Syntax
link-bundle-utilization trigger-threshold value
Parameters value — Enter the percentage of port-channel bandwidth that triggers trac monitoring on port-channel
members, from 0 to 100.
Default Disabled
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# link-bundle-utilization trigger-threshold 10
Supported Releases 10.2.0E or later
mode
Congures a front-panel unied port group to operate in Fibre Channel or Ethernet mode, or a QSFP28-DD or QSFP28 port group to
operate in Ethernet mode, with the specied speed on activated interfaces.
Syntax
mode {Eth {100g-2x | 100g-1x | 50g-2x | 40g-2x | 40g-1x | 25g-8x [fabric-
expander-mode] | 25g-4x | 10g-8x | 10g-4x} | FC {32g-4x | 32g-2x | 32g-1x |
16g-4x | 16g-2x | 8g-4x}}
Parameters
• mode Eth — Congure a port group in Ethernet mode and set the speed to:
– 100g-2x — Split a QSFP28-DD port into two 100GE interfaces.
– 100g-1x — Reset a QSFP28 port group to 100GE mode.
– 50g-2x — Split a QSFP28 port into two 50GE interfaces.
– 40g-2x — Split a port group into two 40GE interfaces.
– 40g-1x — Set a port group to 40G mode for use with a QSFP+ 40GE transceiver.
182 Interfaces