Connectivity Guide

Parameters
• restricted — Applies only to the odd-numbered port within the port group. The even-numbered port in
the port group is disabled. Supported speeds are:
– 100g-1x
– 40g-1x
– 25g-4x
– 10g-4x
• unrestricted — Applies to both the odd-numbered and even-numbered ports within the port group.
Supported speeds are:
– 100g-1x
– 50g-2x
– 40g-1x
Default Unrestricted
Command mode PORT-GROUP
Usage information Enter the profile command to congure breakout interfaces. Use the port command to specify the speed.
The Z9264F-ON switch has a total of 64 physical ports and can support a maximum of 128 logical ports. To view
the ports that belong to a port group, use the show port-group command.
Example
OS10(config)# port-group 1/1/2
OS10(conf-pg-1/1/2)# profile restricted
Supported releases 10.4.3.0 or later
scale-prole vlan
Congures the L2 VLAN scale prole on a switch.
Syntax
scale-profile vlan
Parameters None
Defaults Not congured
Command Mode CONFIGURATION
Usage Information Use the VLAN scale prole when you scale the number of VLANs so that the switch consumes less memory.
Enable the scale prole before you congure VLANs on the switch. The scale prole globally applies L2 mode on all
VLANs you create and disables L3 transmission. The no version of the command disables L2 VLAN scaling. To
enable L3 routing trac on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported Releases 10.4.0E(X2) or later
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
186 Interfaces