Connectivity Guide

-- Unit 1 --
Status : up
System Identifier : 1
Down Reason : user-triggered
Digital Optical Monitoring : disable
Supported Releases 10.4.3.0 or later
show vlan
Displays the current VLAN conguration.
Syntax
show vlan [vlan-id]
Parameters vlan-id — (Optional) Enter a VLAN ID, from 1 to 4093.
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
1 down
Supported Releases 10.2.0E or later
shutdown
Disables an interface.
Syntax
shutdown
Parameters None
Default Disabled
Command Mode INTERFACE
Usage Information
This command marks a physical interface as unavailable for trac. Disabling a VLAN or a port-channel causes
dierent behavior. When you disable a VLAN, the L3 functions within that VLAN are disabled, and L2 trac
continues to ow. Use the shutdown command on a port-channel to disable all trac on the port-channel, and
the individual interfaces. Use the no shutdown command to enable a port-channel on the interface. The
shutdown and description commands are the only commands that you can congure on an interface that is
a port-channel member.
Example
OS10(config)# interface ethernet 1/1/7
OS10(conf-if-eth1/1/7)# no shutdown
Supported Releases 10.2.0E or later
192 Interfaces