Connectivity Guide

OS10(config)# do write memory
OS10(config)# do reload
Supported Releases 10.3.0E or later
switchport access vlan
Assigns access VLAN membership to a port in L2 Access or Trunk mode.
Syntax
switchport access vlan vlan-id
Parameters vlan vlan-id — Enter the VLAN ID number, from 1 to 4093.
Default VLAN 1
Command Mode INTERFACE
Usage Information This command enables L2 switching for untagged trac and assigns a port interface to default VLAN1. Use this
command to change the assignment of the access VLAN that carries untagged trac. You must create the VLAN
before you can assign an access interface to it. The no version of this command resets access VLAN membership
on a L2 access or trunk port to VLAN 1.
Example
OS10(conf-if-eth1/1/3)# switchport mode access
OS10(conf-if-eth1/1/3)# switchport access vlan 100
Supported Releases 10.2.0E or later
switchport mode
Places an interface in L2 Access or Trunk mode.
Syntax
switchport mode {access | trunk}
Parameters
• access — Enables L2 switching of untagged frames on a single VLAN.
• trunk — Enables L2 switching of untagged frames on the access VLAN, and of tagged frames on the VLANs
specied with the
switchport trunk allowed vlan command.
Default
access
Command Mode INTERFACE
Usage Information
• If you assign an IP address to an interface, you cannot use this command to enable L2 switching — you must
rst remove the IP address.
• The access parameter automatically adds an interface to default VLAN1 to transmit untagged trac. Use the
switchport access vlan command to change the access VLAN assignment.
•
The trunk parameter congures an interface to transmit tagged VLAN trac. You must manually congure
VLAN membership for a trunk port with the switchport trunk allowed vlan command.
• Use the no switchport command to remove all L2 congurations when you congure an L3 mode
interface.
• Use the no switchport mode command to restore a trunk port on an interface to L2 Access mode on
VLAN1.
Example
OS10(conf-if-eth1/1/7)# switchport mode access
196 Interfaces