Connectivity Guide

21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
Example (with
zoneset name)
OS10# show fc zoneset set
ZoneSetName ZoneName ZoneMember
==================================================================
set hba1 21:00:00:24:ff:7b:f5:c8
10:00:00:90:fa:b8:22:19
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
hba2 20:01:00:0e:1e:e8:e4:99
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1f
20:35:78:2b:cb:6f:65:57
Supported Releases 10.3.1E or later
zone default-zone permit
Enables access between all logged-in FC nodes of the vfabric in the absence of an active zoneset conguration.
Syntax
zone default-zone permit
Parameters None
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
A default zone advertises a maximum of 255 members in the registered state change notication (RSCN)
message. The no version of this command disables access between the FC nodes in the absence of an active
zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported Releases 10.3.1E or later
zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Parameters zoneset-name — Enter an existing zoneset name.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
After you disable an active zoneset, the zone default-zone permit command conguration takes eect.
Based on this conguration, the default zone allows or denies access between all the logged-in FC nodes of the
vfabric. The no version of this command deactivates the zoneset.
238 Fibre Channel