Connectivity Guide

Parameters None
Defaults Disabled
Command Mode VLAN INTERFACE
Usage Information
Enable FIP snooping on a VLAN only after enabling the FIP snooping feature globally using the feature fip-
snooping command. OS10 supports FIP snooping on a maximum of 12 VLANs. The no version of this command
disables FIP snooping on the VLAN.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping enable
Supported Releases 10.4.0E(R1) or later
p-snooping fc-map
Congures the FC map value for a specic VLAN.
Syntax
fip-snooping fc-map fc-map
Parameters fc-map — Enter the FC map ID, from 0xefc00 to 0xefcff.
Defaults Not congured
Command Mode VLAN INTERFACE
Usage Information
The no version of this command disables the FC map conguration.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
Supported Releases 10.4.0E(R1) or later
p-snooping port-mode
Sets FIP snooping port mode for interfaces.
Syntax
fip-snooping port-mode {enode | enode-transit | fcf | fcf-transit}
Parameters
enode | enode-transit | fcf | fcf-transit—Enter the keyword to set FIP snooping port mode.
Defaults ENode port mode
Command Mode INTERFACE
Usage Information
OS10 supports this conguration only on a switch running FSB mode, and on Ethernet and port-channel interfaces.
You cannot congure FIP snooping port mode on a port channel member.
Use this command to change the port mode. By default, the port mode of an interface is set to ENode. Congure
the port mode only after you enable FIP snooping. Before you disable FIP snooping, reset the port mode to its
default value, ENode.
246 Fibre Channel