Connectivity Guide

Usage Information This command enables LLDP globally for all Ethernet PHY interfaces, except on those interfaces where you
manually disable LLDP. The no version of this command disables LLDP globally irrespective of whether you
manually disable LLDP on an interface.
Example
OS10(config)# lldp enable
Supported Releases 10.3.1E or later
lldp holdtime-multiplier
Congures the multiplier value for the hold time in seconds.
Syntax
lldp holdtime-multiplier integer
Parameters integer — Enter the holdtime-multiplier value in seconds, from 2 to 10.
Default 4 seconds
Command Mode CONFIGURATION
Usage Information Hold time is the amount of time in seconds that a receiving system waits to hold the information before discarding
it. Formula: Hold Time = (Updated Frequency Interval) X (Hold Time Multiplier). The no version of this command
resets the value to the default.
Example
OS10(config)# lldp holdtime-multiplier 2
Supported Releases 10.2.0E or later
lldp med fast-start-repeat-count
Congures the number of packets sent during the activation of the fast start mechanism.
Syntax
lldp-med fast-start-repeat-count number
Parameters number — Enter the number of packets sent during the activation of the fast start mechanism, from 1 to 10.
Default 3
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# lldp med fast-start-repeat-count 5
Supported Releases 10.2.0E or later
lldp med
Enables or disables LLDP-MED on an interface.
Syntax
lldp med {enable | disable}
Parameters
• enable — Enable LLDP-MED on the interface.
• disable — Disable LLDP-MED on the interface.
Default Enabled with network-policy TLV
302 Layer 2