Connectivity Guide

lldp receive
Enables or disables the LLDP packet reception on a specic interface.
Syntax
lldp receive
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information Enable LLDP globally on the system before using the lldp receive command. The no version of this command
disables the reception of LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp receive
Supported Releases 10.2.0E or later
lldp reinit
Congures the delay time in seconds for LLDP to initialize on any interface.
Syntax
lldp reinit seconds
Parameters seconds — Enter the delay timer value in seconds, from 1 to 10.
Default 2 seconds
Command Mode CONFIGURATION
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
Supported Releases 10.2.0E or later
lldp timer
Congures the rate in seconds at which LLDP packets send to the peers.
Syntax
lldp timer seconds
Parameters seconds — Enter the LLDP timer rate in seconds, from 5 to 254.
Default 30 seconds
Command Mode CONFIGURATION
Usage Information The no version of this command sets the LLDP timer back to its default value.
Example
OS10(config)# lldp timer 25
Supported Releases 10.2.0E or later
Layer 2 305