Connectivity Guide

lldp tlv-select basic-tlv
Enables or disables TLV attributes to transmit and receive LLDP packets.
Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-description
| system-capabilities | management-address [ipv4 | ipv6]}
Parameters
• port-description — Enable or disable the port description TLV.
• system-name — Enable or disable the system TLV.
• system-description — Enable or disable the system description TLV.
• system-capabilities — Enable or disable the system capabilities TLV.
• management-address — Enable or disable the management address TLV (IPv4 and IPv6).
• management-address ipv4 - Enable or disable only the IPv4 management address TLV.
• management-address ipv6 - Enable or disable only the IPv6 management address TLV.
Default Enabled
Command Mode INTERFACE
Usage Information The no form of the command disables TLV attribute transmission and reception in LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
Supported Releases 10.2.0E or later
lldp tlv-select dot1tlv
Enables or disables the dot.1 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot1tlv { port-vlan-id | link-aggregation}
Parameters
• port-vlan-id — Enter the port VLAN ID.
• link-aggregation — Enable the link aggregation TLV.
Default Enabled
Command Mode INTERFACE
Usage Information The lldp tlv-select dot1tlv link-aggregation command advertises link aggregation as a dot1 TLV
in the LLDPDUs. The no version of this command disables TLV transmissions.
Example (Port)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv port-vlan-id
Example (Link
Aggregation)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Supported Releases 10.2.0E or later
306 Layer 2