Connectivity Guide

Example for automatic installation
1 Use the mv image_name onie-installer command to rename the image as onie-installer.
mv PKGS_OS10-Base-10.3.1B.144-installer-x86_64.bin onie-installer
2 After renaming, the system enters the ONIE: Install mode. Enter the command onie-discovery-start, which
automatically discovers the onie-installer image from the DHCP server.
ONIE:/ # onie-discovery-start
discover: installer mode detected. Running installer.
Starting: discover... done.
ONIE:/ # Info: eth0: Checking link... up.
Info: Trying DHCPv4 on interface: eth0
ONIE: Using DHCPv4 addr: eth0: 10.10.10.17 / 255.0.0.0
Info: eth1: Checking link... down.
ONIE: eth1: link down. Skipping configuration.
ONIE: Failed to configure eth1 interface
ONIE: Starting ONIE Service Discovery
Info: Fetching tftp://10.10.10.2/onie-installer-x86_64-dellemc_s4148fe_c2338 ...
Info: Fetching tftp://10.10.10.2/onie-installer-dellemc_s4148fe_c2338 ...
Info: Fetching tftp://10.10.10.2/onie-installer-x86_64-bcm ...
Info: Fetching tftp://10.10.10.2/onie-installer-x86_64 ...
Info: Fetching tftp://10.10.10.2/onie-installer ...
ONIE: Executing installer: tftp://10.10.10.2/onie-installer
...
...
...
Press <DEL> or <F2> to enter setup.
Welcome to GRUB!
GNU GRUB version 2.02~beta2+e4a1fe391
OS10-B
EDA-DIAG
ONIE Booting `OS10-A'
Loading OS10 ...
[ 3.883826] kvm: already loaded the other module
[ 3.967628] dummy-irq: no IRQ given. Use irq=N
[ 3.973212] mic_init not running on X100 ret -19
[ 3.980168] esas2r: driver will not be loaded because no ATTO esas2r devices were found
[ 4.021676] mtdoops: mtd device (mtddev=name/number) must be supplied
[ 5.092316] i8042: No controller found
[ 5.108356] fmc_write_eeprom fake-design-for-testing-f001: fmc_write_eeprom: no busid
passed, refusing all cards
[ 5.120111] intel_rapl: driver does not support CPU family 6 model 77
[ 4.226593] systemd-fsck[493]: OS10-SYSROOT1: clean, 23571/426544 files, 312838/1704960
blocks
Debian GNU/Linux 8 OS10 ttyS0
Dell EMC Networking Operating System (OS10)
OS10 login:
Manual installation
If a DHCP server is not available, you can manually install an OS10 software image. If the IP address for the Management port (eth0) is
not automatically discovered, ONIE sets the IP address to 192.168.3.10. You must manually congure the Management port and
congure the software image le to start installation.
1 Save the OS10 software image on an SCP/TFTP/FTP server.
2 Power up the switch and select ONIE Rescue for manual installation.
3 (Optional) Stop DHCP discovery if the device boots to ONIE Install.
$ onie-discovery-stop
Getting Started
33