Connectivity Guide

NOTE: However, the zero-touch deployment (ZTD) application requires this functionality. While ZTD is in progress, the system
assigns an IP address to the default VLAN to establish connectivity. After ZTD is complete, the system removes the IP address
assigned to the default VLAN.
You can place VLANs and other logical interfaces in L3 mode to receive and send routed trac.
1 Create a VLAN in CONFIGURATION mode, from 1 to 4093.
interface vlan vlan-id
2 Assign an IP address and mask to the VLAN in INTERFACE-VLAN mode.
ip address ip-address/prefix-length [secondary]
ip-address/prefix—length — Enter the IP address in dotted-decimal A.B.C.D/x format.
secondary — Enter the interface backup IP address.
Assign IP address to VLAN
OS10(config)# interface vlan 200
OS10(conf-if-vl-200)# ip address 10.1.15.1/8
View VLAN conguration
OS10(conf-if-vl-200)# do show interface vlan
Vlan 1 is up, line protocol is up
Address is , Current address is
Interface index is 69208865
Internet address is not set
MTU 1532 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 240
Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface
status change:
Vlan 200 is up, line protocol is up
Address is , Current address is
Interface index is 69209064
Internet address is not set
MTU 1532 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 240
Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface
status change:
Vlan 320 is up, line protocol is up
Address is , Current address is
Interface index is 69209184
Internet address is 20.2.11.1/24
MTU 1532 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 240
Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface
status change:
View VLAN conguration
You can view conguration information related to VLANs using show commands.
View the VLAN status and conguration information in EXEC mode.
show vlan
Layer 2
371