Connectivity Guide

ow-based
Enables ow-based monitoring. The monitoring session can be: local, RPM, or ERPM.
Syntax
flow-based enable
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage Information The no version of this command disables the ow-based monitoring.
Example
OS10(conf-mon-local-1)# flow-based enable
OS10(conf-mon-rpm-source-2)# flow-based enable
OS10(conf-mon-erpm-source-3)# flow-based enable
Supported Releases 10.2.0E or later
ip
Congures the IP time-to-live (TTL) value and the dierentiated services code point (DSCP) value for the ERPM trac.
Syntax
ip {ttl ttl-number | dscp dscp-number}
Parameters
• ttl-number — Enter the TTL value, from 1 to 255.
• dscp-number — Enter the DSCP value, from 0 to 63.
Default
• TTL: 255
• DSCP: 0
Command Mode MONITOR-SESSION (ERPM)
Usage Information The no version of this command removes the congured TTL and DSCP values.
Example
OS10(conf-mon-erpm-source-10)# ip ttl 16
OS10(conf-mon-erpm-source-10)# ip DSCP 63
Supported Releases 10.4.0E(R1) or later
monitor session
Creates a session for monitoring trac with port monitoring.
Syntax
monitor session session-id type [local | rpm-source | erpm-source]
Parameters
• session-id — Enter a monitor session ID, from 1 to 18.
• local — (Optional) Enter a local monitoring session.
• rpm-source — (Optional) Enter a remote monitoring session.
• erpm-source — (Optional) Enter an encapsulated remote monitoring session.
382 Layer 2