Connectivity Guide

show ip vrf
Displays the VRF instance information.
Syntax
show ip vrf [management | vrf-name]
Parameters
• management—Enter the keyword management to display information corresponding to the management
VRF instance.
• vrf-name—Enter the name of the non-default VRF instance to display information corresponding to that
VRF instance.
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show ip vrf
VRF-Name Interfaces
default Mgmt1/1/1
Eth1/1/1-1/1/2
Vlan1
management
OS10# show ip vrf management
VRF-Name Interfaces
management
Supported Releases 10.4.0E(R1) or later
update-source-ip
Congures a source IP interface for any leaked route in a VRF instance.
Syntax
update-source-ip interface interface-id
To undo this conguration, use the no update-source-ip command.
Parameters
• interface interface-id — Enter the loopback interface identier. The range is from 0 to 16383.
Default Not congured
Command Mode VRF CONFIGURATION
Example
OS10(conf-vrf)# update-source-ip loopback 1
Supported Releases 10.4.2E or later.
Bidirectional Forwarding Detection
The Bidirectional Forwarding Detection (BFD) protocol rapidly detects communication failures between two adjacent routers. BFD replaces
link-state detection mechanisms in existing routing protocols. It also provides a failure detection solution for links with no routing protocols.
Layer 3
407