Connectivity Guide
ip route bfd interval milliseconds min_rx milliseconds multiplier value role [active |
passive]
CONFIGURATION Mode
NOTE: By default, OSPF uses the following BFD parameters for it's neighbors: min_tx = 200 msec, min_rx = 200 msec,
multiplier = 3, role = active. The values are congured in milliseconds
Disabling BFD for IPv4 Static Routes
If you disable BFD, all static route BFD sessions are torn down.
A nal Admin Down packet is sent to all neighbors on the remote systems, and those neighbors change to the Down state. To disable BFD
for IPv4 static routes, use the following command.
Disable BFD for static routes.
no ip route bfd
CONFIGURATION Mode
Establishing BFD Sessions for IPv6 Static Routes
To establish a BFD session for IPv6 static routes, use the following command.
Establish BFD sessions for all neighbors that are the next hop of a static route.
ipv6 route bfd [interval interval min_rx min_rx multiplier value role {active | passive}]
CONFIGURATION Mode
NOTE
: By default, OSPF uses the following BFD parameters for it's neighbors: min_tx = 200 msec, min_rx = 200 msec,
multiplier = 3, role = active. The values are congured in milliseconds
Establishing BFD Sessions for IPv6 Static Routes in a non-default VRF
instance
To establish a BFD session for IPv6 static routes in a non-default VRF instance, use the following command.
Establish BFD sessions for all neighbors that are the next hop of a static route.
ipv6 route bfd [vrf vrf-name] [interval interval min_rx min_rx multiplier value role {active
| passive}]
CONFIGURATION Mode
NOTE
: By default, OSPF uses the following BFD parameters for it's neighbors: min_tx = 200 msec, min_rx = 200 msec,
multiplier = 3, role = active. The values are congured in milliseconds
Changing IPv6 Static Route Session Parameters
To change parameters for IPv6 static route sessions, use the following command.
Change parameters for all static route sessions.
Layer 3
421