Connectivity Guide

ipv6 route bfd interval milliseconds min_rx milliseconds multiplier value role [active |
passive]
CONFIGURATION Mode
NOTE: By default, OSPF uses the following BFD parameters for it's neighbors: min_tx = 200 msec, min_rx = 200 msec,
multiplier = 3, role = active. The values are congured in milliseconds
Disabling BFD for IPv6 Static Routes
To disable BFD for IPv6 static routes, use the following command.
Disable BFD for static routes.
no ipv6 route bfd
CONFIGURATION Mode
BFD commands
bfd
Enables BFD sessions with specied neighbors.
Syntax
bfd
Parameters None
Default Not congured
Command Mode
ROUTER-NEIGHBOR
ROUTER-TEMPLATE
Usage Information
• Use the bfd command to congure BFD sessions with a specied neighbor or neighbors which inherit a BGP
template. Use the neighbor {ip-address | ipv6-address} command in ROUTER-BGP mode to
specify the neighbor. Use the
template template-name command in ROUTER-BGP mode to specify a
BGP template. Use the no bfd command in ROUTER-NEIGHBOR mode to disable BFD sessions with a
neighbor.
• Use the bfd all-neighbors command to congure L3 protocol-specic BFD parameters for all BFD
sessions between discovered neighbors. The BFD parameters you congure override the global session
parameters congured with the bfd interval command.
Example
OS10(conf)# router bgp 1
OS10(config-router-bgp-1)# neighbor 10.1.1.1
OS10(config-router-neighbor)# bfd
OS10(config-router-neighbor)# no shutdown
OS10(config)# router bgp 300
OS10(config-router-bgp-300)# template ebgppg
OS10(config-router-template)# bfd
OS10(config-router-template)# exit
OS10(config-router-bgp-300)# neighbor 3.1.1.1
OS10(config-router-neighbor)# inherit template ebgppg
OS10(config-router-neighbor)# no shutdown
422 Layer 3