Connectivity Guide

Usage Information Use the neighbor ip-address command in ROUTER-BGP mode to specify a neighbor. Use the bfd
disable command to disable BFD sessions with the neighbor.
Example
OS10(conf)# router bgp 1
OS10(config-router-bgp-1)# neighbor 10.1.1.1
OS10(config-router-neighbor)# bfd disable
Supported releases 10.4.1.0 or later
bfd enable
Enables BFD on all interfaces on the switch.
Syntax
bfd enable
Parameters None
Default BFD is disabled.
Command Mode CONFIGURATION
Usage Information Before you congure BFD for static routing or a routing protocol, enable BFD globally on each router in a BFD
session. To globally disable BFD on all interfaces, enter the no bfd enable command.
Example
OS10(config)# bfd enable
Supported releases 10.4.1.0 or later
bfd interval
Congures parameters for all BFD sessions on the switch.
Syntax
bfd interval milliseconds min_rx milliseconds multiplier number role {active |
passive}
Parameters
• interval milliseconds — Enter the time interval for sending control packets to BFD peers, from 100 to
1000. Dell EMC recommends using more than 100 milliseconds.
• min_rx milliseconds — Enter the maximum waiting time for receiving control packets from BFD peers,
from 100 to 1000. Dell EMC recommends using more than 100 milliseconds.
•
multiplier number — Enter the number of consecutive packets that must not be received from a BFD
peer before the session state changes to Down, from 3 to 50.
• role {active | passive} — Enter active if the router initiates BFD sessions. Both BFD peers can be
active at the same time. Enter passive if the router does not initiate BFD sessions, and only responds to a
request from an active BFD to initialize a session.
Default
The time interval for sending control packets to BFD peers is 200 milliseconds.
The maximum waiting time for receiving control packets from BFD peers is 200 milliseconds.
The number of consecutive packets that must be received from a BFD peer is 3.
The BFD role is active.
Command Mode CONFIGURATION
424 Layer 3