Connectivity Guide

2 Enter admin for both the default user name and password to log into OS10. You are automatically placed in EXEC mode.

OS10#

Remote access Linux shell

ssh linuxadmin@ip-address

password: linuxadmin

Congure Management IP address

To remotely access OS10, assign an IP address to the management port. The management interface is used for out-of-band (OOB)

management purposes.

1 Congure the management interface from CONFIGURATION mode.

interface mgmt 1/1/1

2 By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.

no ip address dhcp

3 Congure an IPv4 or IPv6 address on the Management interface in INTERFACE mode.

ip address A.B.C.D/mask

ipv6 address A:B/prefix-length

4 Enable the Management interface in INTERFACE mode.

no shutdown

Congure Management interface

OS10(config)# interface mgmt 1/1/1

OS10(conf-if-ma-1/1/1)# no ip address dhcp

OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24

OS10(conf-if-ma-1/1/1)# no shutdown

Management Route Conguration

To set up remote access to OS10, congure a management route after you assign an IPv4 or IPv6 address to the Management port. The

Management port uses the default management route to communicate with a dierent network. Management routes are separate from

IPv4 and IPv6 routes and are only used to manage the system through the Management port.

management route 192.168.100.0/24 1.1.1.1

ip route 192.168.200.0/24 2.2.2.2

management route 192.168.30.0/24 managementethernet

ip route 192.168.40.0/24 interface ethernet 1/1/1

Before conguring the static IPv4 address for Management port, remove the DHCP setting using the no ip address dhcp command.

Congure a management route to the network in CONFIGURATION mode. Repeat the command to congure multiple routes for the

Management port.

management route {ipv4-address/mask | ipv6-address/prefix-length}

{forwarding-router-address | managementethernet}

• ipv4-address/mask — Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prex-length

format (/x).

• ipv6-address/prefix-length — Enter an IPv6 address in x:x:x:x::x format with the prex length in /x format. The prex range

is /0 to /128.

• forwarding-router-address — Enter the next-hop IPv4/IPv6 address of a forwarding router for network trac from the

Management port.

Getting Started