Connectivity Guide

soft-reconguration inbound
Enables soft-reconguration for a neighbor.
Syntax
soft-reconfiguration inbound
Parameters None
Default Not congured
Command Modes ROUTER-BGP-NEIGHBOR-AF
Usage Information This command is not supported on a peer-group level. To enable soft-reconguration for peers in a peer-group, you
must enable this command at a per-peer level. With soft-reconguration inbound, all updates received from this
neighbor are stored unmodied, regardless of the inbound policy. When inbound soft-reconguration is performed
later, the stored information generates a new set of inbound updates. The no version of this command disables
soft-reconguration inbound for a BGP neighbor.
Example (IPv4)
OS10(conf-router-neighbor)# address-family ipv4 unicast
OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound
Example (IPv6)
OS10(conf-router-neighbor)# address-family ipv6 unicast
OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound
Supported Releases 10.3.0E or later
template
Creates a peer-group template to assign it to BGP neighbors.
Syntax
template template-name
Parameters template-name — Enter a peer-group template name. A maximum of 16 characters.
Default Not congured
Command Mode CONFIG-ROUTER-BGP
Usage Information Members of a peer-group template inherit the conguration properties of the template and share the same update
policy. The no version of this command removes a peer-template conguration.
NOTE: To congure these settings for a non default VRF instance, you must rst enter the ROUTER-
CONFIG-VRF sub mode using the following commands:
1 Enter the ROUTER BGP mode using the router bgp as-number command.
2 From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name
command.
Example
OS10(conf-router-bgp-10)# template solar
OS10(conf-router-bgp-template)#
Supported Releases 10.3.0E or later
Layer 3 491