Connectivity Guide

timers
Adjusts BGP keepalive and holdtime timers.
Syntax
timers keepalive holdtime
Parameters
• keepalive—Enter the time interval, in seconds, between keepalive messages sent to the neighbor routers,
from 1 to 65535.
• holdtime—Enter the time interval, in seconds, between the last keepalive message and declaring a router
dead, from 3 to 65535.
Default keepalive 60 seconds; holdtime 180 seconds
Command Mode ROUTER-BGP
Usage Information The congured timer value becomes eective after a BGP hard reset. The timer values negotiate from peers. The
no version of this command resets the value to the default.
Example
OS10(conf-router-bgp)# timers 30 90
Supported Releases 10.3.0E or later
vrf
Enters the CONFIG-ROUTER-VRF command mode.
Syntax
vrf vrf-name
Parameters None
Default None
Command Mode ROUTER-BGP
Usage Information This mode allows you to apply BGP congurations to non-default VRFs.
Example
OS10(config)#router bgp 100
OS10(config-router-bgp-100)#
OS10(config-router-bgp-100)#vrf vrf_test1
OS10(config-router-bgp-100-vrf)#
Supported Releases 10.3.0E or later
weight
Assigns a default weight for routes from the neighbor interfaces.
Syntax
weight number
Parameters number—Enter a number as the weight for routes, from 1 to 4294967295.
Default 0
Command Mode ROUTER-BGP-NEIGHBOR
492 Layer 3