Connectivity Guide
• IPv6 forwarding is permanently disabled on the management Ethernet interface so that it remains in Host mode and does not operate
as a router regardless of the ipv6 address autoconfig setting.
If necessary, you can manually disable IPv6 processing on an interface so that the congured IPv6 addresses do not take eect. The IPv6
addresses take eect again when you re-enable IPv6.
If you disable IPv6 and congure a Layer (L2) interface in Layer (L3) mode, IPv6 is not automatically re-enabled on the interface. You must
manually re-enable it.
A link-local address automatically generates when you re-enable IPv6 on an interface with the ipv6 enable command.
Disable and enabIe IPv6
OS10(config)# interface ethernet 1/1/8
OS10(conf-if-eth1/1/8)# ipv6 address 2111:dddd:0eee::22/64
OS10(conf-if-eth1/1/8)# no ipv6 address autoconfig
OS10(conf-if-eth1/1/8)# no ipv6 enable
OS10(conf-if-eth1/1/8)# ipv6 enable
Display IPv6 status
OS10# show interface ethernet 1/1/20
Ethernet 1/1/20 is up, line protocol is up
Hardware is Dell EMC Eth, address is ec:f4:bb:fb:fa:30
Current address is ec:f4:bb:fb:fa:30
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR 1.0M
Wavelength is 850
Receive power reading is 0.0
Interface index is 17305562
Internet address is 20.20.20.1/24
Mode of IPv4 Address Assignment: MANUAL
Interface IPv6 oper status: Enabled
Link local IPv6 address: fe80::eef4:bbff:fefb:fa30/64
Global IPv6 address: 2020::1/64
...
OS10# show ipv6 interface brief
Interface Name admin/protocol IPV6 Address/Link-Local Address IPv6 Oper Status
===================================================================================
Ethernet 1/1/1:1 up / up fe80::eef4:bbff:fefb:f9f0/64
2017::1/64 Enabled
Ethernet 1/1/20 up / up fe80::eef4:bbff:fefb:fa30/64
2020::1/64 Enabled
Management 1/1/1 up / up fe80::eef4:bbff:fefb:f9ef/64 Enabled
Vlan 1 up / up fe80::eef4:bbff:fefb:fa59/64 Enabled
IPv6 addresses
An IPv6 address consists of a 48-bit global routing prex, optional 16-bit subnet ID, and a 64-bit interface identier in the extended
universal identier (EUI)-64 format.
IPv6 128-bit addresses are represented as a series of eight 16-bit hexadecimal elds separated by colons: x:x:x:x:x:x:x:x.
2001:0db8:0000:0000:0000:0000:1428:57a
Leading zeros in each eld are optional. You can also use two colons (::) to represent successive hexadecimal elds of zeros, but you can
use this short version only one time in each address:
2001:db8::1428:57ab
In the following example, all the addresses are valid and equivalent:
• 2001:0db8:0000:0000:0000:0000:1428:57ab
510
Layer 3