Connectivity Guide
Parameters
• vrf vrf-name — (Optional) Enter vrf then the name of the VRF to clear the IPv6 routes corresponding to
that VRF.
• *— Clears all routes and refreshes the IPv6 routing table. Trac ow for all the routes in the switch is
aected.
•
A::B/mask — Removes the IPv6 route and refreshes the IPv6 routing table. Trac ow in the switch is
aected only for the specied route.
Default Not congured
Command Mode EXEC
Usage Information This command does not remove the static routes from the routing table.
Example
OS10# clear ipv6 route *
Supported Releases 10.3.0E or later
ipv6 address
Congures a global unicast IPv6 address on an interface.
Syntax
ipv6 address ipv6–address/prefix-length
Parameters ipv6-address/prex-length — Enter a full 128-bit IPv6 address with the network prex length, including the 64-bit
interface identier.
Defaults None
Command Mode INTERFACE
Usage Information
An interface can have multiple IPv6 addresses. To congure an IPv6 address in addition to the link-local address,
use the ipv6 address ipv6-address/mask command and specify the complete 128-bit IPv6 address. To
congure a globally unique IPv6 address by entering only the network prex and length, use the ipv6 address
ipv6-prefix/prefix-length eui-64 command.
The no version of this command removes the IPv6 address on the interface.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/64
Supported Releases 10.3.0E or later
ipv6 address autocong
Acquires global IPv6 addresses by using the network prex obtained from RAs.
Syntax
ipv6 address autoconfig
Parameters None
Defaults Disabled except on the management interface
Command Mode INTERFACE
Usage Information
• This command sets an interface in Host mode to perform IPv6 stateless auto-conguration by discovering
prexes on local links, and adding an EUI-64 based interface identier to generate each IPv6 address. The
Layer 3 517