Connectivity Guide
Command Mode INTERFACE
Usage Information The no version of this command restores the default MTU value advertised in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd mtu 2500
Supported Releases 10.4.0E(R1) or later
ipv6 nd other-cong-ag
Sends RA messages that tell hosts to use stateful autoconguration to obtain nonaddress-related information.
Syntax
ipv6 nd other-config-flag
Parameters None
Defaults Not congured
Command Mode INTERFACE
Usage Information The no version of this command disables the other-config-flag option in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd other-config-flag
Supported Releases 10.4.0E(R1) or later
ipv6 nd prex
Congures the IPv6 prexes that are included in messages to neighboring IPv6 routers.
Syntax
ipv6 nd prefix {ipv6-prefix | default} [no-advertise] [no autoconfig] [no-rtr-
address] [off-link] [lifetime {valid-lifetime seconds | infinite} {preferred-
lifetime seconds | infinite}]
Parameters
• ipv6-prefix — Enter an IPv6 prex in x:x::y/mask format to include the prex in RA mesages. Include
prexes that are not already in the subnets on the interface.
• default — Congure the prex parameters advertised in all subnets congured on the interface.
• no-advertise — (Optional) Do not advertise the specied prex. By default, all prexes in congured
subnets advertise.
•
no-autoconfig — (Optional) Sets AdvAutonomous to Off for the specied prex in the radvd.conf le.
This setting tells hosts to not use this prex for address autoconguration. By default, AdvAutonomous is On.
• no-rtr-address — (Optional) Sets AdvRouterAddr to Off for the prex in the radvd.conf le. The Off
setting tells hosts to not use the advertising router's address for on-link determination. By default,
AdvRouterAddr is On.
• off-link — (Optional) Sets AdvOnLink to Off for the prex in the radvd.conf le. The Off setting tells
hosts to not use this prex for on-link determination. By default, AdvOnLink is On.
• lifetime {valid-lifetime seconds | infinite} — (Optional) Sets AdvValidLifetime in
seconds for the prex in the radvd.conf le. The prex is valid for on-link determination only for the specied
lifetime. The default is 86400 seconds (1 day). The infinite setting allows the prex to be valid for on-link
determination with no time limit.
• lifetime {preferred-lifetime seconds | infinite} — (Optional) Sets
AdvPreferredLifetime in seconds for the prex in the radvd.conf le. IPv6 addresses generated from the
prex using stateless autoconguration remain preferred for the congured lifetime. The default is 14400
522 Layer 3