Connectivity Guide

Example
OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5
Supported Releases 10.2.0E or later
log-adjacency-changes
Enables logging of syslog messages regarding changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
Parameters None
Default Disabled
Command Mode ROUTER-OSPF
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# log-adjacency-changes
Supported Releases 10.2.0E or later
max-metric router-lsa
Congures OSPF to advertise a maximum metric on a router so that it is not desired as an intermediate hop from other routers.
Syntax
max-metric router-lsa
Parameters None
Default Not congured
Command Mode ROUTER-OSPF
Usage Information Routers in the network do not prefer other routers as the next intermediate hop after they calculate the shortest
path. The no version of this command disables the maximum metric advertisement conguration.
Example
OS10(conf-router-ospf-10)# max-metric router-lsa
Supported Releases 10.2.0E or later
maximum-paths
Enables forwarding of packets over multiple paths.
Syntax
maximum—paths number
Parameters number —Enter the number of paths for OSPF, from 1 to 128.
Default 64
Command Mode ROUTER-OSPF
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# maximum-paths 1
Supported Releases 10.2.0E or later
550 Layer 3