Connectivity Guide
Usage Information Dell EMC recommends keeping the default setting for this command. If you change the time interval between
VRRP advertisements on one router, change it on all routers. The no version of this command sets the VRRP
advertisements timer interval back to its default value, 1 second or 100 centisecs.
Example
OS10(conf-eth1/1/6-vrid-250)# advertise-interval 120 centisecs 100
Supported Releases 10.2.0E or later
authentication-type
Enables authentication of VRRP data exchanges.
Syntax
authentication-type simple-text password
Parameters
simple-text password — Enter a simple text password.
Default Disabled
Command Mode INTERFACE-VRRP
Usage Information With authentication enabled, OS10 ensures that only trusted routers participate in routing in an autonomous
network. The no version of this command disables authentication of VRRP data exchanges.
Example
OS10(conf-ethernet1/1/6-vrid-250)# authentication simple-text eureka
Supported Releases 10.2.0E or later
preempt
Permits or preempts a backup router with a higher priority value to become the master router.
Syntax
preempt
Parameters None
Default Enabled
Command Mode INTERFACE-VRRP
Usage Information VRRP uses preempt to determine what happens after a VRRP backup router becomes the master. With preempt
enabled by default, VRRP switches to a backup if that backup router comes online with a priority higher than the
new master router. If you disable preempt, VRRP switches only if the master fails. The no version of this command
disables preemption.
Example
OS10(conf-eth1/1/5-vrid-254)# preempt
Supported Releases 10.2.0E or later
priority
Assigns a VRRP priority value for the VRRP group. The VRRP uses this value during the master election process.
Syntax
priority number
Parameters number — Enter a priority value, from 1 to 254.
612 Layer 3