Connectivity Guide

Supported Releases 10.2.0E or later
vrrp-ipv6-group
Assigns a VRRP group identication number to an IPv6 interface.
Syntax
vrrp-ipv6–group vrrp-id
Parameters vrrp-id — Enter a VRRP group identication number, from 1 to 255.
Default Not congured
Command Mode INTERFACE-VRRP
Usage Information The VRRP group only becomes active and sends VRRP packets when you congure a virtual IP address. When you
delete the virtual address, the VRRP group stops sending VRRP packets. The no version of this command
removes the vrrp-ipv6–group conguration.
Example
OS10(conf-if-eth1/1/7)# vrrp-ipv6-group 250
Supported Releases 10.2.0E or later
vrrp version
Sets the VRRP version for the IPv4 group.
Syntax
vrrp version {2 | 3}
Parameters
• 2 — Set to VRRP version 2.
• 3 — Set to VRRP version 3.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command disables the VRRP version for the IPv4 group.
Example
OS10(config)# vrrp version 2
Supported Releases 10.2.0E or later
616 Layer 3