Connectivity Guide

Command Mode VLAN INTERFACE
Usage Information When you enable MLD snooping globally, the conguration is applied to all the VLAN interfaces. You can disable the
MLD snooping on specied VLAN interfaces. The no version of this command disables the MLD snooping on the
specied VLAN interface.
Example
OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# no ipv6 mld snooping
Supported Releases 10.4.1.0 or later
ipv6 mld snooping enable
Enables MLD snooping globally.
Syntax
ipv6 mld snooping enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage Information The no version of this command disables the MLD snooping.
Example
OS10(config)# ipv6 mld snooping enable
Supported Releases 10.4.1.0 or later
ipv6 mld snooping fast-leave
Enables fast leave in MLD snooping for specied VLAN.
Syntax
ipv6 mld snooping fast-leave
Parameters None
Default Disabled
Command Mode VLAN INTERFACE
Usage Information The fast leave option allows the MLD snooping switch to remove an interface from the multicast group
immediately on receiving the leave message. The no version of this command disables the fast leave
functionality.
Example
OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# ipv6 mld snooping fast-leave
Supported Releases 10.4.1.0 or later
ipv6 mld snooping last-member-query-interval
Congures the time interval between group-specic MLD query messages.
Syntax
ipv6 mld snooping last-member-query-interval query-interval-time
Parameters query-interval-time—Enter the query time interval in milliseconds, ranging from 100 to 65535.
638 Multicast