Connectivity Guide

ip pim sparse-mode sg-expiry-timer
Enables expiry timers globally for all sources.
Syntax
ip pim [vrf vrf-name] sparse-mode sg-expiry-timer seconds
Parameters
• vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
• seconds—Enter the number of seconds the S, G entries are retained. The range is from 211 to 65535
seconds.
Default 210 seconds
Command Mode CONFIGURATION
Usage Information This command congures the expiry timers for all S, G entries.
Example
OS10# configure terminal
OS10(config)# ip pim sparse-mode sg-expiry-timer 500
Supported Releases 10.4.3.0 or later
ip pim ssm-range
Species the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access-list-name}
Parameters
• vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
• access-list-name—Enter the name of the access list.
Default 232.0.0.0/8
Command Mode CONFIGURATION
Usage Information When ACL rules change, the ACL and PIM modules apply the new rules automatically. When you remove the SSM
ACL, PIM-SSM is supported only for the default SSM range.
Example
OS10# configure terminal
OS10(config)# ip pim ssm-range ssm
Supported Releases 10.4.3.0 or later
show ip pim interface
Displays information about IP PIM-enabled interfaces.
Syntax
show ip pim [vrf vrf-name] interface
Parameters vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
Default None
Command Mode EXEC
650 Multicast