Connectivity Guide

controller ovsdb
Changes the mode to CONFIGURATION-NVE-OVSDB from where you can congure the controller parameters.
Syntax
controller ovsdb
Parameters None
Default None
Command mode CONFIGURATION-NVE
Usage information
The controller conguration initiates the OVSDB service on the OS10 switch.
The no version of this command stops the OVSDB service. The no version command fails if any ports are
congured as controller-managed ports or IP address conguration.
NOTE: Before removing the controller conguration from the device, you must delete all controller-
managed ports and IP address conguration.
Example
OS10(config)# nve
OS10(config-nve)# controller ovsdb
Supported releases 10.4.3.0 or later
ip port ssl
Congures the OVSDB controller reachability information such as IP address, port number, and the connection type of session, in the
switch.
Syntax
ip ip-address port port-number ssl
Parameters
• ip-address — Specify the IP address of the OVSDB controller to connect with.
• port-number — Specify the port number through which the connection to the OVSDB controller is made.
Default
For an OVSDB-based controller, congure the following:
• Port number as 6640
• Connection type as SSL
Command mode CONFIGURATION-NVE-OVSDB
Usage information
Currently, the only supported OVSDB controller is the NSX controller. no version of this command removes the
connection to the OVSDB controller.
Example
OS10(config)# nve
OS10(config-nve)# controller ovsdb
OS10(config-nve-ovsdb)# ip 10.11.66.110 port 6640 ssl
Supported releases 10.4.3.0 or later
774 VXLAN