Connectivity Guide

Parameters
• name — Enter the name of the prex list.
• num — Enter the sequence list number.
• A.B.C.D/x — Enter the source network address and mask in /prex format (/x).
• ge — Enter to indicate the network address is greater than or equal to the range specied.
• le — Enter to indicate the network address is less than or equal to the range specied.
• prefix-len — Enter the prex length.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command removes the specied prex list.
Example
OS10(config)# ip prefix-list seqprefix seq 65535 deny 10.10.10.1/16 ge 10
Supported Release 10.3.0E or later
ip prex-list seq permit
Congures a lter to permit route ltering from a specied prex list.
Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
• name — Enter the name of the prex list.
• num — Enter the sequence list number.
• A.B.C.D/x — Enter the source network address and mask in /prex format (/x).
• ge — Enter to indicate the network address is greater than or equal to the range specied.
• le — Enter to indicate the network address is less than or equal to the range specied.
• prefix-len — Enter the prex length.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command removes the specied prex list.
Example
OS10(config)# ip prefix-list seqprefix seq 65535 permit 10.10.10.1/16 le 30
Supported Release 10.3.0E or later
ipv6 access-group
Congures an IPv6 access group.
Syntax
ipv6 access-group access-list-name {in | out}
Parameters
• access-list-name — Enter the name of an IPv6 ACL. A maximum of 140 characters.
• in — Apply the ACL to incoming trac.
• out — Apply the ACL to outgoing trac.
910 Access Control Lists