Connectivity Guide

Parameters
• name — (Optional) Enter the name of the IPv6 prex-list.
• num — Enter the sequence number of the specied IPv6 prex-list.
• A::B/x — Enter the IPv6 address and mask in /prex format (/x).
• ge — Enter to indicate the network address is greater than or equal to the range specied.
• le — Enter to indicate the network address is less than or equal to the range specied.
• prefix-len — Enter the prex length.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command removes the specied prex-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 deny AB20::1/128 ge 10
Supported Release 10.3.0E or later
ipv6 prex-list seq permit
Congures a lter to permit route ltering from a specied prex-list.
Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
• name — (Optional) Enter the name of the IPv6 prex-list.
• num — Enter the sequence number of the specied IPv6 prex list.
• A::B/x — Enter the IPv6 address and mask in /prex format (/x).
• ge — Enter to indicate the network address is greater than or equal to the range specied.
• le — Enter to indicate the network address is less than or equal to the range specied.
• prefix-len — Enter the prex length.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command removes the specied prex-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 permit AB10::1/128 ge 30
Supported Release 10.3.0E or later
mac access-group
Congures a MAC access group.
Syntax
mac access-group access-list-name {in | out}
Parameters
• access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
• in — Apply the ACL to incoming trac.
• out — Apply the ACL to outgoing trac.
Access Control Lists 913