Connectivity Guide

• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not congured
Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter.
The count, byte, and log options are not supported on the S5148F-ON platform.
Example
OS10(conf-ipv6-acl)# permit ipv6 any any count capture session 1
Supported Releases 10.2.0E or later
permit tcp
Congures a lter to permit TCP packets meeting the lter criteria.
Syntax
permit tcp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [[A.B.C.D |
A.B.C.D/x | any | host ip-address [operator] ] [ack | fin | psh | rst | syn |
urg] [capture | count | dscp value | fragment | log]
Parameters
• A.B.C.D — Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
NOTE: The control-plane ACLs do not support the any parameter.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
• ack — (Optional) Set the bit as acknowledgement.
• fin — (Optional) Set the bit as nish—no more data from sender.
• psh — (Optional) Set the bit as push.
• rst — (Optional) Set the bit as reset.
• syn — (Optional) Set the bit as synchronize.
• urg — (Optional) Set the bit set as urgent.
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values, 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
• operator — (Optional) Enter a logical operator to match the packets on the specied port number. The
following options are available:
– eq — Equal to
– gt — Greater than
– lt — Lesser than
– neq — Not equal to
– range — Range of ports, including the specied port numbers.
Access Control Lists
919