Connectivity Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

921

922

923

924

925

926

927

928

929

930

• byte — (Optional) Count bytes the lter processes.

• dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.

• fragment — (Optional) Use ACLs to control packet fragments.

• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.

Default Not congured

Command Mode IPV4-ACL

Usage Information

OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The

no version of this command removes the lter, or use the no seq sequence-number command if you know

the lter’s sequence number.

The count, byte, and log options are not supported on the S5148F-ON platform.

Example

OS10(config)# ip access-list egress

OS10(conf-ipv4-acl)# seq 5 deny icmp any any capture session 1 log

Supported Releases 10.2.0E or later

seq deny icmp (IPv6)

Assigns a sequence number to deny ICMP messages while creating the lter.

Syntax

seq sequence-number deny icmp [A::B | A::B/x | any | host ipv6-address] [A::B |

log]

Parameters

• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing

number, from 1 to 16777214.

• A::B — Enter the IPv6 address in hexadecimal format separated by colons.

• A::B/x — Enter the number of bits that must match the IPv6 address.

• any — (Optional) Enter the keyword any to specify any source or destination IP address.

• host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.

• capture — (Optional) Capture packets the lter processes.