Connectivity Guide

• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of 00:00:00:00:00:00 applies.
• any — (Optional) Set all routes to be subject to the lter:
– protocol-number — (Optional) Enter the protocol number identied in the MAC header, from 600 to
.
– capture — (Optional) Enter the capture packets the lter processes.
– cos — (Optional) Enter the CoS value, from 0 to 7.
– vlan — (Optional) Enter the VLAN number, from 1 to 4093.
Default Not congured
Command Mode MAC-ACL
Usage Information The no version of this command removes the lter, or use the no seq sequence-number command if you
know the lter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan
2
Supported Releases 10.2.0E or later
seq permit icmp
Assigns a sequence number to allow ICMP messages while creating the lter
Syntax
seq sequence-number permit icmp [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count | dscp value |
fragment | log]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• A.B.C.D — Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not congured
Command Mode IPV4-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter, or use the no seq sequence-number command if you know
the lter’s sequence number.
934 Access Control Lists