Service Manual
To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa {number}
command then the ip msdp cache-rejected-sa {number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range is from 0 to 32766.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Related Commands
• show ip msdp sa-cache rejected-sa — display the rejected SAs in the SA cache.
ip msdp default-peer
Dene a default peer from which to accept all source-active (SA) messages.
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list that contains the RP
address that should be treated as the default peer. If no access list is specied, then all
SAs from the peer are accepted.
Defaults Not congured.
Command Modes CONFIGURATION
Multicast Source Discovery Protocol (MSDP) 1015