Service Manual
tc-ush-standard
Enable the MAC address ushing after receiving every topology change notication.
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced
Usage Information By default, Dell Networking OS implements an optimized ush mechanism for MSTP. This mechanism helps in
ushing the MAC addresses only when necessary (and less often) allowing for faster convergence during topology
changes. However, if a standards-based ush mechanism is needed, this knob command can be turned on to
enable ushing MAC addresses after receiving every topology change notication.
1042 Multiple Spanning Tree Protocol (MSTP)