Service Manual
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added output for LSA throttling timers.
8.3.7.0 Introduced on the S4810.
7.9.1.0 Added support for VRF.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area
0.
The following describes the show ip ospf command shown in the following example.
Line Beginning
with
Description
“Routing Process...” Displays the OSPF process ID and the IP address associated with the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...” Displays the delay and hold time congured for this process ID.
“Convergence
Level”
“Min LSA....” Displays the intervals set for LSA transmission and acceptance.
“Number of...” Displays the number and type of areas congured for this process ID.
Example
Dell# show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
Dell#
Related Commands
• show ip ospf database — display information about the OSPF routes congured.
• show ip ospf interface — display the OSPF interfaces congured.
• show ip ospf neighbor — display the OSPF neighbors congured.
1128 Open Shortest Path First (OSPFv2 and OSPFv3)