Service Manual
Related Commands telnet — telnet to another device.
ip telnet vrf
Congures a TELNET client to use a specic VRF.
Syntax
ip telnet [vrf vrf-name]
To undo the TELENT client conguration, use the ip telnet [vrf vrf-name] command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify the VRF that is used by
the TELENT client.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant FTOS Command
Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information If you congure a TELNET client to use a specic VRF, then you need not explicitly specify the same VRF during
the TELNET client sessions corresponding to that VRF.
Example
Dell(conf)# ip telnet vrf vrf1
Dell(conf)# do telnet 10.10.10.2
Dell(conf)# no ip telnet vrf vrf1
Dell(conf)#
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP trac.
Syntax
ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface interface command.
Parameters
interface Enter the following keywords and slot/port[/subport] or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
Control and Monitoring 113