Service Manual

vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display OSPF
neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are displayed.
interface
(OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults None
Command Modes
EXEC
EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell# show ipv6 ospf 3 neighbor gi 1/2
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Te 1/2
Dell#
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path rst (SPF) calculation.
S4048–ON
Syntax
timers spf delay holdtime
1192 Open Shortest Path First (OSPFv2 and OSPFv3)