Service Manual
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 4294967295. The default is 5
seconds.
holdtime Enter a number as the hold time. The range is from 0 to 4294967295. The default is 10
seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command Modes ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S6000-ON, S6000, S4820T, S4810, S5000.
Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly but
requires more CPU usage.
Example
Dell# conf
Dell(conf)# ipv6 router ospf 1
Dell(conf-ipv6-router_ospf)# timer spf 2 5
Dell(conf-ipv6-router_ospf)# show config
!
ipv6 router ospf 1
timers spf 2 5
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)# end
Dell#
Open Shortest Path First (OSPFv2 and OSPFv3) 1193