Service Manual

NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and 3x/32
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on S6000, S4810, S4820T, Z9000,
Z9500, and S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Usage Information
Dell Networking OS supports standard access lists for the SSM range. You cannot use extended ACLs for
conguring the SSM range. If you congure an extended ACL and then used in the ip pim ssm-range
{access list name} conguration, an error is reported.
However, if you congure ip pim ssm-range {access list name} rst and then you congure the ACL
as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range.
Dell Networking OS-recommended best-practices are to congure the standard ACL, and then apply the ACL to
the SSM range. After the SSM range is applied, the changes are applied internally without requiring clearing of the
tree information base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM) modules apply the new rules
automatically.
When you congure the SSM range, Dell Networking OS supports SSM for congured group range as well as the
default SSM range.
When you remove the SSM ACL, PIM SSM is supported for the default SSM range only.
1218 PIM-Sparse Mode (PIM-SM)